Ada Suite 7.1 HD Manual de Instalação descarregar pdf (Página 22)

Audio Design Associates

www.ada-usa.com

Setting up the Suite 7.1 with Front Panel Controls and Display

Although the optimum method for setting up the Suite 7.1 is with setup software described later, you

can still set up the Suite 7.1 with the front panel controls if the unit that is so equipped. To activate the

setup function of the Suite 7.1, press and hold down the Mode knob for four seconds.

Navigating Within the Setup Menu

The Mode and Input knobs are used to navigate and select through the front panel setup menu. Once

you have entered the setup menu, you generally navigate to the function you want to change with the

Mode knob and change the parameter of that function with the Input knob. The following sections

illustrate how you set up each of the Suite 7.1’s numerous functions. Once you are in the setup mode,

you can exit it by navigating to arrow next to the M > and pressing the mode knob. This sends you back

to the main control display. You can access the previous display by navigating to arrow next to the <P

and pressing the mode knob.

Setting Tone, Balance, and Volume Presets Levels

The Suite 7.1 allows you to individually fine tune the Tone, Balance, Volume for all eight channels and

store these adjustments into memory. There are four separate presets that you can store into memory

that can later be recalled to suit a particular environmental situation or source.

Bass and Treble for Memory Recall

The advanced tone feature of the Suite 7.1 allows you to adjust tone for each of the eight output

channels. Each of the four tone presets can be subdivided into two groups. This extra flexibility permits

you to have different tone settings for the front and rear channels under the same tone preset.

Selecting Channels for Tone Adjustment

1. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall

setup. The cursor will flash over the T in TONE.

2. Rotate the Mode knob until the cursor is over the T in T/B/VOL SET.

3. Press the Mode knob. The display will change again to the tone store display. There are two groups

that can be stored into memory: GROUP A and GROUP B.

4. When the cursor flashes over G in Group A, rotate the Input knob to select between Group A and

5. Select the tone group you want to adjust.

6. Once the tone group is selected, rotate the Mode knob until you reach the second line in the

display. The cursor will flash over the L for the Left channel.

7. Rotate the input knob until an asterisk appears next to the letter that corresponds to the channel.

This will include that channel in the group for tone adjustment. (e.g. L * R * C *)

8. Once you have included all channels for tone adjustment, rotate the Mode knob clockwise until

the cursor flashes over the T in TREB.

Adjusting the Treble Level

1. Rotate the Input knob clockwise to increase the level of treble in 1 dB increments up to +20 dB.

2. Rotate the Input knob counterclockwise to decrease the level of treble in 1 dB increments down to

-20 dB.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 47 48

Sem comentários

Ada Suite 7.1 HD Manual de Instalação Página 22