Suite 7.1 Installation Manual
www.ada-usa.com 29
To Setup Bass Management for Your Surround Speakers:
1. If you are not already in the Bass Management setup menu, follow steps 1-4 from above.
2. Rotate the Mode knob until the cursor flashes over the S in SURROUND.
3. Refer to the owner’s manual of your front left and right speakers to determine whether they are
designed to safely reproduce low frequencies.
4. If your center speaker is designed to operate in full range, rotate the Input knob so the display reads:
SURROUND LARGE.
5. If your center speaker is not designed to operate in full range, rotate the Input knob so the display
reads: SURROUND SMALL. The center will have low frequencies rolled off at the selected crossover
frequency. This low frequency information is then re-routed to the subwoofer channel.
6. If you do not have a center channel speaker, select SURROUND NONE and the Suite 7.1 will re route
the surround channel information to the other active speakers.
To Setup Bass Management for Your Surround Back Speakers:
1. If you are not already in the Bass Management setup menu, follow steps 1-4 from above.
2. Rotate the Mode knob until the cursor flashes over the B in BACK.
3. Refer to the owner’s manual of your front left and right speakers to determine whether they are
designed to safely reproduce low frequencies.
4. If your surround back speakers are designed to operate in full range, rotate the Input knob so the
display reads: BACK LARGE 1 OR 2. Note that if you have selected large surround speakers, you can
only select large surround back speakers.
5. If your center speaker is not designed to operate in full range, rotate the Input knob so the display
reads: BACK SMALL 1 OR 2. The center will have low frequencies rolled off at the selected crossover
frequency. This low frequency information is then re-routed to the subwoofer channel. Note that if
you have selected large surround speakers, you can only select large surround back speakers.
6. If you do not have a center channel speaker, select BACK NONE and the Suite 7.1 will re route any
discrete surround back channel information to the other active speakers.
To Setup Your Subwoofer:
1. If you are not already in the Bass Management setup menu, follow steps 1-4 from above.
2. Rotate the Mode knob until the cursor flashes over the S in SUB.
3. If you are using a subwoofer, rotate the Input knob so the display reads SUB YES. Low frequency
effects (LFE) are then routed to the subwoofer.
4. If you have selected SMALL or NONE for the main, center, surround, or surround back speakers,
frequencies below the crossover frequency are also routed to the subwoofer channel.
Setting the Subwoofer Crossover Frequency:
1. If you are not already in the Bass Management setup menu, follow steps 1-4 from above.
2. Rotate the Mode knob until the cursor flashes over the S in SUBXOVER .
3. Rotate the Input knob to adjust the subwoofer crossover frequency, which can be set in 10 Hz
increments from OFF to 220 Hz .
4. When you set the crossover frequency to the OFF position, the crossover circuit of the Suite 7.1 is
defeated and the full audio spectrum is sent to all the speakers. This gives you the option of using
an external crossover or the crossover built in to your subwoofer and avoids the possibility of
“double filtering”.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais